Fan assembly
This part of the installation is self-explanatory and also described conclusively in the enclosed documentation. The two already mentioned fans from Balck Noise are used:
However, the tight fit of the fans and especially the correct installation in the case are important, where the stabilizing elements of the slot bracket assembly must be used without fail!Dust carousel from Noiseblocker. This page later points to the cooler Peter:
Of course, the propeller wall also has a front view:
Exciting thing and the superfluous regulatory authority
Cooling with 12 volts means getting the maximum out of it. However, since this is not at all necessary in the case of the card we tested, you can gladly lower the voltage to further reduce the sound level. Since you install two fans, you also need two regulators or voltage dividers, unless you use the variant we determined as the ideal compromise, where the fan above the GPU is operated with 7 volts and the other with 5 volts. Then such a simple part as in the illustration will do:
Thus, you can safely dispense with an elaborate fan control, as the test on the next page impressively proves. So let’s get down to business and torture Alm-Peter a bit with Radeon’s hot breath.
31 Antworten
Kommentar
Lade neue Kommentare
Urgestein
Urgestein
Urgestein
Urgestein
Urgestein
Urgestein
1
Urgestein
Urgestein
Veteran
1
Mitglied
Urgestein
Urgestein
Veteran
Urgestein
Mitglied
Urgestein
Mitglied
Alle Kommentare lesen unter igor´sLAB Community →