Optics and haptics
Finally freed from the protective covers, we can take a first look at the case. A front with gray fabric is something special for a change, but looks very good in my opinion. One USB Type-C, two USB 3.0 Type-A and a combo port for the headset are available on the front. That’s all most ATX cases have either, so it’s perfectly adequate.
On the right, the side panel is almost completely covered with small holes for the air supply, on the left only the upper half.
The pictures of the interior show why this is the case. In the upper area of the left side, two large 140mm fans of the “Aspect” model draw air towards the graphics card. The lower part then only accommodates the two 2.5″ brackets and a large opening for the motherboard’s back, neither of which needs to be supplied with much fresh air. But it certainly wouldn’t have done any harm either.
Inside, part of the riser card is already pre-installed on the center strut. The small extension from the accessories is inserted there before installation so that the correct height can be reached. Fractal Design limits itself to the most necessary front panel connections for the motherboard, only the power switch and power LED have to be connected.
The casing is well manufactured, cleanly painted and makes a high-quality impression.
27 Antworten
Kommentar
Lade neue Kommentare
Urgestein
Veteran
Urgestein
Urgestein
Veteran
Veteran
Mitglied
Moderator
Moderator
Veteran
Urgestein
Moderator
Veteran
Mitglied
Neuling
Veteran
Mitglied
Mitglied
Neuling
Alle Kommentare lesen unter igor´sLAB Community →