Hold-Up Time (hold-up time)
Hold-Up Time is a bridging time that describes the period during which the specified output power continues to be provided in the event of an input voltage failure. Even normal power supplies can bridge short-term power failures up to the range of seconds by means of appropriately dimensioned input storage electrolytic capacitors. The bypass time is longer and the power ok signal is accurate. It would be nice if the latter could reach 16 ms or longer to meet the requirements of the ATX specification.
Timings
The power supply also supports alternative power saving modes!
Inrush current (starting current or inrush current)
All power supplies generate a so-called starting current, which often exceeds their nominal current consumption by far. The causes are the charging of the different capacitances in the input circuit and in the EMC filters, the build-up of the magnetic field in the transformer core and even the charging of the capacitors in the output filter. Only when the converter is operating stably does this input current drop back to normal values. specific The inrush current is very low at 115 V but extremely high at 230 V.
- 1 - Einführung, technische Daten und Testreport
- 2 - Unboxing, Kabel und Schutzschaltungen
- 3 - Teardown: Topologie, Komponenten, Verarbeitung
- 4 - Load Regulation, Ripple Suppression, Transient Resonse
- 5 - Hold-Up Time, Timings, Inrush-Current
- 6 - Average Efficiency and PF
- 7 - Betriebsgeräusch und Lüfter
- 8 - Zusammenfassung und Fazit
19 Antworten
Kommentar
Lade neue Kommentare
Urgestein
1
Urgestein
1
Urgestein
1
Veteran
Veteran
Urgestein
Urgestein
Mitglied
Urgestein
Mitglied
Mitglied
Veteran
1
Veteran
Urgestein
Veteran
Alle Kommentare lesen unter igor´sLAB Community →