Since I’d like to go to the factories of the contract manufacturers and always try to take a look behind the scene, but just the cute little Corona virus lurks grinning behind every Far Eastern corner and i’m hämisch with a hearty “You can’t pass”, it must direct an older collection of images. The production is exemplary and many things are subject to the same or even higher standards.
So suitcasepacked and on it goes! Once arrived, showered and slept, I make my way through the production line of a large contract manufacturer and accompany a Be Quiet! Straight Power E10 from the bare board to the ready-to-ship six-pack – something you’re not sure to see often. And that’s why I publish it. The approval and approval of the manufacturer and the finisher can usually be obtained with a slightly second distance without any problems.
First, however, the supplier provides the (still) empty boards and assigns them to the respective models.
- 1 - Wir starten mit der leeren Platine
- 2 - Automatische Bestückung - Teil 1
- 3 - Zwischenstopp: Teilbestückte Platine
- 4 - Bestückung mit SMD-Bauelementen
- 5 - Automatische Bestückung - Teil 2
- 6 - Automatische Bestückung - Kontrolle
- 7 - Zwischenstopp und Überführung
- 8 - Manuelles Bestücken mit Bauelementen
- 9 - Kürzen der Anschlüsse
- 10 - Kühlkörper einsetzen...
- 11 - ...und verschrauben
- 12 - Kabelbaum einsetzen
- 13 - Kabelmanagement anschließen
- 14 - Kabel abbinden
- 15 - Finale Bestückung
- 16 - Automatisches Wellenlötbad
- 17 - Überwachung des Lötvorgangs
- 18 - Abschluss des Lötvorgangs
- 19 - Qualitätskontrolle nach dem Löten
- 20 - Korrektur und Nachlöten
- 21 - Grobreinigung
- 22 - Feinreinigung und Seriennummer
- 23 - Sichtkontrolle
- 24 - Test aller Anschlusskabel
- 25 - Netzanschluss vorbereiten
- 26 - Hochzeit! Die Platine kommt ins Gehäuse
- 27 - Lüftermontage
- 28 - Geschlossene Veranstaltung
- 29 - Heiße Sache: Burn-In-Test
- 30 - Burn-In-Test: Aus dem in den Ofen in die Freiheit
- 31 - Funktionstest nach dem Burn-In
- 32 - ATE-Test (Automatic Test Equipment)
- 33 - HiPot-Test: Hochspannung pur
- 34 - Finaler Test aller Kabel und Stecker
- 35 - Label aufkleben und Endsäuberung
- 36 - Finale Kontrolle
- 37 - Boxing: Ab in die Kiste
- 38 - Versandfertig im Sechserpack
Kommentieren