Cooling Reviews Watercooling

The sub-zero number: Intel Core i9-11900K vs. Cooler Master MasterLiquid ML360 Sub-Zero – the impossibility of the dreamed possible

Now let’s get to the stakes. I have done the assembly quite quickly and was therefore also quickly ready for use. The voltage increases, but so do the temperatures under load. When gaming, the promised 5.3 GHz is reached for the first time – on a maximum of 2 cores, but mostly only one. Games that can use many cores extensively will therefore hardly be able to take much advantage here, because then everything folds down to 5.1 GHz and sometimes even further to the well-known 4.8 GHz allcore. Such a Peltier element not only solves problems, but unfortunately also creates new ones at the same time.

And this is also where the cycle of insanity begins with the full loads, once you do the math. In practice, I measured a whopping 176 watts at the 6+2 pin connection of the cooling at full load, whereby in this case you still have to add the waste heat of the CPU of up to 260 watts, which in total as a 436 watt bomb must then be dissipated by the 360 mm radiator. Even the three fans with a little over 1900 rpm don’t help anymore, the temperature drops very quickly and the CPU throttles.

Let’s now compare different loads and the achieved temperatures in the recommended automatic mode and 100% fan speeds with the temperatures of the conventional 360 AiO from the launch review with controlled fans:

Workload Tmin Tmax AiO Average
Idle (18 to 35 watts) 15 °C 31 °C 35 °C
Borderlands 3 Ultra HD (75 Watt) 35 °C 52 °C 49 °C
Borderlands 3 WQHD (96 Watt) 51 °C 70 °C 69 °C
Borderlands 3 720p (120 watts) 53 °C 79 °C 74 °C
Cinebench R23 (260 watts) 85 °C 100 °C (throttling) 89 °C

 

Summary and conclusion

It’s a nice technical gimmick, granted. Cooler Master has here with the MasterLiquid ML360 Sub-Zero a very unusual product with high rarity value and extremely good workmanship at the start, but that alone does not save such a project of course. Up to about 100 watts, the Cryo cooler does a passable job, but then it’s time for normal compact or custom water coolers, because the waste heat of the CPU and the power loss of the thermoelectric cooling element add up. And this is unfortunately also noticeable and audible, of course in addition to the extremely loud pump.

However, you can forget about efficiency here anyway, you have to sacrifice that for exclusivity due to the design. But even hoping for the extra boost isn’t really fully covered. The AiO compact water cooling from MSI used for the launch review was the better (and especially quieter) choice on average. And was the CPU at least measurably faster now? Unfortunately, the answer to this must also be no, because the package power was almost always above 100 watts.

Well, what do we learn from this? Advertising and hope for a miracle are one thing, reality unfortunately is another. It was an experiment, nothing more. However, there is hardly any practical benefit to be gained from this in everyday life, even if Intel may see it differently. Too bad, really.

Cooler Master MasterLiquid ML360 Sub-Zero (MLZ-D36M-A19PK-12)

Radio Code Heldenlagernd133,19 €*Stand: 19.04.24 14:00
Merkunalagernd299,90 €*Stand: 19.04.24 09:53
Bora ComputerLieferzeit 3-4 Werktage401,83 €*Stand: 19.04.24 18:48
*Alle Preise inkl. gesetzl. MwSt zzgl. Versandkosten und ggf. Nachnahmegebühren, wenn nicht anders beschriebenmit freundlicher Unterstützung von geizhals.de

Kommentar

Lade neue Kommentare

Derfnam

Urgestein

7,517 Kommentare 2,029 Likes

360 Ocken? Und kein Schallschutzkopfhörer dabei? Hm.

Antwort 2 Likes

Martin Gut

Urgestein

7,753 Kommentare 3,559 Likes

Technik bleibt eben an die Physik gebunden. Auch wenn man viel tolles entwickeln kann, zaubern geht trotzdem nicht. :)

Antwort Gefällt mir

Skitzo

Mitglied

14 Kommentare 6 Likes

Ich glaube ein Ryzen 3 3100 oder 3300 Düfte damit entspannt gekühlt werden können. Über die Zweckmäßigkeit in dieser Konstellation möchte ich mich nicht äußern 😅

Antwort Gefällt mir

komatös

Mitglied

96 Kommentare 60 Likes

Entspannt gekühlt? Ich würde sagen das Silizium stirbt den Erfrierungtot :ROFLMAO: Nicht zuletzt wäre es, wie Säue vor die Perlen zu werfen.

Antwort Gefällt mir

D
Dezor

Veteran

492 Kommentare 215 Likes

Und täglich grüßt das Murmeltier. Alle paar Jahre wieder will ein Hersteller mit thermoelektrischer Kühlung die Grenzen der Physik ausdehnen, bisher immer ohne Erfolg. Mit einer richtigen großen Custom WaKü sollte die zusätzliche Abwärme durch das Peltier-Element auch dank größerer möglicher Oberfläche kein Problem sein. Meines Wissens nach gibt es da aber nichts auf dem Markt, ein Hinweis darauf, dass man das Peltier-Element vielleicht doch eher in kleinen Kühlboxen und nicht auf der CPU verwenden sollte.

Bitte nicht falsch verstehen, das Prinzip als solches finde ich spannend und begrüße es auch immer, wenn Hersteller mal etwas neues ausprobieren.

Antwort 1 Like

M
McFly_76

Veteran

395 Kommentare 136 Likes

Den Einsatz von Peltier-Elementen im PC ( GPU, CPU ) finde ich aus mehreren Gründen komplett deplaziert und dieser Test bestätigt es mir schon wieder.
Das was Cooler Master hier versucht hat, die CPU zu kühlen, schafft jede 360-er AIO mit Kupferradiator und kostet dabei nur 1/3 des Preises.

Intel® Cryo Cooling Technology = :rolleyes:​

Antwort 1 Like

D
Deridex

Urgestein

2,212 Kommentare 846 Likes

Ich finde die Peltier-Elemente durchaus interressant. Aber beim aktuellen Stand dieser Technik halte ich die Peltier-Elemente nicht für den Einsatz in einer Wasserkühlung geeignet.

Antwort Gefällt mir

Mr5

Mitglied

15 Kommentare 1 Likes

Zitat Igor: "Und ich werde auch keine großen Übertaktungs-Klimmzüge mehr machen, der läuft eh schon auf der letzten Rille."

:LOL:

Antwort 1 Like

D
Denniss

Urgestein

1,514 Kommentare 547 Likes

Ziemlich sinnlos das ganze wenn das Peltier-Element fast soviel Strom säuft wie die CPU. Das der Radiator diese massive Hitze nicht mehr vollständig abgeben kann ist nur logisch

Antwort Gefällt mir

ro///M3o

Veteran

340 Kommentare 239 Likes

Wobei hier die Perlen "denitiv" die Ryzens wären wenn man den test liest.
Was für eine sinnlose Verschwendung von allem möglichen was Coolermaster da gemacht hat und Intel auch noch bewirbt was noch viel unverständlicher ist :poop: Es gibt dafür quasie kein sinvolles Einsatzgebiet.
Ein kleinerer Chiller ist da weit "sinnvoller".
Wer sowas tatsächlich in Erwähgung zieht, hat nämlich finanziell auch ganz andere Möglichkeiten.

Antwort 3 Likes

big-maec

Urgestein

826 Kommentare 475 Likes

Tja, mal schauen 12V*14,6A=176W für alles ist ja auch schon eine Hausnummer. Hier liegt wahrscheinlich der Teufel im Detail der Regelung.

Antwort Gefällt mir

n
noxcivi

Mitglied

31 Kommentare 4 Likes

Mit Peltiers in PCs hab ich mich schon beim Bau meiner ersten Custom Wakü vor17 Jahren beschäftigt. Es war und ist ernüchternd. Wenn es auf pures Kühlungs-P/L ankommt, bekommt man mit zig anderen Methoden bessere Kühlung. Beispiel: Schon ab 100 Euronen bekommt man temperaturgeregelte (industrielle) Wasserkühler mit oder ohne integrierter Pumpe, die man mit seiner Wakü kombinieren kann.

Antwort Gefällt mir

Danke für die Spende



Du fandest, der Beitrag war interessant und möchtest uns unterstützen? Klasse!

Hier erfährst Du, wie: Hier spenden.

Hier kannst Du per PayPal spenden.

About the author

Igor Wallossek

Editor-in-chief and name-giver of igor'sLAB as the content successor of Tom's Hardware Germany, whose license was returned in June 2019 in order to better meet the qualitative demands of web content and challenges of new media such as YouTube with its own channel.

Computer nerd since 1983, audio freak since 1979 and pretty much open to anything with a plug or battery for over 50 years.

Follow Igor:
YouTube Facebook Instagram Twitter

Werbung

Werbung