Cooling Fans Reviews

Fractal Prisma AL-12 PWM ARGB Case Fan Review – Good Fan for Cases and Radiators, even at lower Speeds

Volume flow vs. sound pressure level

You get here a very appealing performance in the case and also on the radiator together with a quite also completely sufficient speed band. The Fractal Prisma AL-12 PWM ARGB is consistently quieter than the reference up to about 55 cfm and even significantly quieter below 40 cfm, only managing slightly less throughput at the top end of the speed range at a similar sound level. This is really top notch, especially since the fan was free of humming and audible vibrations. You can leave it like that, because it doesn’t really get that much better than that.

Those who install the Fractal Prisma AL-12 PWM ARGB should pay attention to structure-borne noise and vibrations, which can quickly find a resonator and then put the fan acoustically on the sidelines, even if the fan is quite well decoupled by the huge rubber corners. Such things are precisely the reason why we work with a large-volume and very rigid chamber and not with a thin and long wind tunnel. This also applies to the end user, who may please pay attention to a good decoupling here.

Volume flow and speeds

Once again we see the somewhat limited speed range at the lower end (at least PWM controlled), although except for this small malus you always need lower speeds than the reference for the same throughput. Otherwise, the curve is similarly balanced to that of the reference fan. The almost linear climb is good, and the curve at the top doesn’t just flatten out either. Kudos for that, too, of course. The fact that the upper limit is limited to 2000 rpm does not detract from the overall effect, as most users will prefer 1500 rpm or less anyway.

So you can see that the fan delivers what we promised (because we know the realities) and not what the manufacturer promises in the data sheet a little too optimistically. But it’s also a fact that the Fractal Prisma AL-12 PWM ARGB delivers more than decent overall and compared to the reference. Also the performance on the radiators, especially at lower speeds can fully convince, even if the fan then of course somewhat decreases. Compared to other fans with nicely colored values in the data sheet, the Fractal Prisma AL-12 PWM ARGB delivers, however, also neatly For this there is a buy tip and it is well deserved. Only the data sheet should be corrected by Fractal, because it would not have been necessary. That’s fine.

Conclusion

Those who can’t or don’t want to do without RGB will surely be happy with the Fractal Prisma AL-12 PWM ARGB. Whether as a case fan, or in use on thick radiators – as long as you don’t prefer the ultimate tornado along with matching accompanying noise, the Fractal Prisma AL-12 PWM ARGB is a really good choice. And we are once again pleased that the fans are obviously getting better in general. Good and detailed tests are certainly conducive to this. In the end, the customer benefits and the provider is happy about honest sales. I’m sure everyone can live with that bomb just fine.

Fractal Design Prisma AL-12 PWM, schwarz, 120mm (FD-FAN-PRI-AL12-PWM)

CSV-Direct.deLagernd im Versandlager - Lieferzeit 2-5 Werktage17,96 €*Stand: 19.04.24 15:41
playox.deAuf Lager, sofort versandfertig Lieferzeit 1-2 Werktage18,56 €*Stand: 19.04.24 15:34
office-partner.deAuf Lager, sofort versandfertig Lieferzeit 1-2 Werktage18,56 €*Stand: 19.04.24 15:46
*Alle Preise inkl. gesetzl. MwSt zzgl. Versandkosten und ggf. Nachnahmegebühren, wenn nicht anders beschriebenmit freundlicher Unterstützung von geizhals.de

 

 

Kommentar

Lade neue Kommentare

RAZORLIGHT

Veteran

355 Kommentare 262 Likes

Langsam wirds richtig schwer sich zu entscheiden, so viele gute Lüfter...
Eine Tabelle mit allen getesteten Lüftern wäre hilfreich.

Ich hoffe ihr testet die 140er Variante des Fractals ebenso 😀

Antwort 4 Likes

RX480

Urgestein

1,858 Kommentare 850 Likes

Aber die guten Lüfter kosten dann soviel, das sich evtl. auch ein besseres Case (x) lohnen würde mit nur
mooore preiswerten Arctics.

(x) ... sprich mehr Platz für größere Radis

Wann gehts denn eigentlich hier weiter: ... mit Vollausbau der Radis

Antwort Gefällt mir

Klicke zum Ausklappem
Pascal TM-Custom

Urgestein

1,122 Kommentare 1,361 Likes

bin ich gerade dran das wird das Thema zum Build ;)

View image at the forums

Antwort 2 Likes

ssj3rd

Veteran

214 Kommentare 142 Likes

Warum Testet ihr nicht gleichzeitig immer auch die 140er Variante?

Antwort Gefällt mir

Pascal TM-Custom

Urgestein

1,122 Kommentare 1,361 Likes

Weil der Test Pro Lüfter schon Haufen Aufwand ist. Und du siehst ja schon pro Lüfter das es so einiges zu schreiben gibt. Reviews sollte man nicht auf 20 Seite. Packen. Einzeln getestet und immer wieder Abwechslung sollte immer sein.

Antwort Gefällt mir

Igor Wallossek

1

10,173 Kommentare 18,757 Likes

Der Test einschließlich Schreiben kostet pro Lüfter mehr als einen Arbeitstag. Wir schrauben die Dinger ja nicht nur auf ein Spielzeugrohr und blasen genau einmal durch. Das ist leider Fleißarbeit mit ständigen Nachjustieren.

Antwort Gefällt mir

RX480

Urgestein

1,858 Kommentare 850 Likes

Da freue ich mich schon drauf!
... bei insgesamt 15 Lüftern ist das dann der oben angesprochene Kostenfaktor

Antwort 1 Like

Capt.Flint

Mitglied

31 Kommentare 21 Likes

Danke für den Test, da war das ja kein Fehlkauf. Dann macht ein auswechseln meiner Prismas ja keinen Sinn. Dann muss ich mir eine andere Komponente zum Basteln aussuchen. Dann wandert das Geld für die geplanten neuen Lüftern in den Sparstrumpf für ne neue Grafikkarte. Bis der voll ist gibt's aber eh ne neue Serie und die wird sicher nicht preiswerter. Werde schon noch was finden um den Rechner mal zerlegen zu "müssen". Die 1080ti wird wahrscheinlich noch eine Generation überspringen müssen.

Antwort Gefällt mir

Pascal TM-Custom

Urgestein

1,122 Kommentare 1,361 Likes

siehst du mit uns spart man Geld ;)

Antwort Gefällt mir

Cool McCool

Mitglied

27 Kommentare 1 Likes

Guten Tach an die Lüfterfans (eventuell Wortspiel :D )

Zuerst großen Dank für die tollen Tests, die landen beinahe täglich auf meinem Bildschirm zum stöbern :)

Eine Frage:
Ich habe mir jetzt als Weihnachtsgeschenk die Prisma in 2x120mm und 5x140mm geholt, um die Tage etwas zum basteln zu haben.
Nun schockiert mich, dass die 140er alle wirklich sehr deutlich rattern, das höre ich bei geschlossenem Define 7 noch aus 1-2m Entfernung.
Es wird mit steigender Drehzahl nur schneller, nicht lauter, ob nun PWM oder DC geregelt und unabhängig der Lage.
Das kommt doch sicher von den Motoren oder?

Meine Alpenföhn Wingboost 3 sind dagegen absolut leise dahingehend.

Antwort Gefällt mir

Pascal TM-Custom

Urgestein

1,122 Kommentare 1,361 Likes

Das könnte vom Motor kommen ja.

Ich hatte die 140er noch nicht in der Messekammer.

Was auffällig ist das es oft bei 140er zu Neben geräuschen kommt und dabei ist der Hersteller egal. Humming, Rattern, Fiepen hab ich jetzt am meisten bei 140er Lüfter festgestellt.

Ich lese aus deinem Text raus das die 120er nicht betroffen sind.

Antwort Gefällt mir

Cool McCool

Mitglied

27 Kommentare 1 Likes

So ist es, die 120er sind unauffällig. Ich empfinde die 140er definitiv nicht als direkt fehlerhaft, mancher hört es vielleicht auch nicht so deutlich, hat ja jeder so sein Paar Ohren :)
Ich werde sie definitiv nicht behalten, das stört mich zu sehr. Bald kommen eine Bestellung von Alphacool :D

Antwort Gefällt mir

Pascal TM-Custom

Urgestein

1,122 Kommentare 1,361 Likes

Lass die Lüfter Mal etwas laufen das kann sich einpendeln. Am Anfang sind alle Lüfter etwas lauter deswegen lass ich bevor ich teste Lüfter 24h auf Max RPM Laufen.

Damit laufen sich die Lager ein und das Fett verteilt sich ordentlich.

Antwort 1 Like

Cool McCool

Mitglied

27 Kommentare 1 Likes

Ja das sollte man wirklich tun, so haben sich meine Aspect von Fractal auch gut eingelaufen. Die Dynamic X irgendwas waren von Anfang an gut.
Die Prisma sind schon älter, die hab ich gebraucht bekommen aber nicht sehr alt und alle 5 haben es.
Würde euch einen zum Test schicken aber mit gebrauchten wäre der Vergleich da auch nich fair 😅

Antwort Gefällt mir

Pascal TM-Custom

Urgestein

1,122 Kommentare 1,361 Likes

Ja gut gebraucht ist immer ein Thema. Ja Tausch die einfach aus mit denn Alphacool Rise 140 falls du die gekauft hast hast du definitiv eine gute Wahl getroffen.

Antwort Gefällt mir

Danke für die Spende



Du fandest, der Beitrag war interessant und möchtest uns unterstützen? Klasse!

Hier erfährst Du, wie: Hier spenden.

Hier kannst Du per PayPal spenden.

About the author

Review Team

Werbung

Werbung